130
Note:
If you enable storm control feature for the ingress rate limit-enabled port, ingress rate limit feature
will be disabled for this port.
For TL-SG2452:
Figure 9-13 Storm Control
The following entries are displayed on this screen:
Storm Control Config
Port Select: Click the Select button to quick-select the corresponding port
based on the port number you entered.
Select: Select the desired port for Storm Control configuration. It is
multi-optional.
Port: Displays the port number of the switch.
Broadcast: Enable/Disable broadcast control feature for the port.
Multicast: Enable/Disable multicast control feature for the port.
UL-Frame: Enable/Disable UL-Frame control feature for the port.
Rate (bps): Select the bandwidth for receiving the specified packet on the port.
The packet traffic exceeding the bandwidth will be discarded.
LAG: Displays the LAG number which the port belongs to.
Note:
If you enable storm control feature for the ingress rate limit-enabled port, ingress rate limit feature
will be disabled for this port.
To Next Page
Loading...
