TP-Link TL-WR1043ND MultiWAN www.sharedband.com
Verify Successful Setup
6) Use an Ethernet cable to connect a computer to the blue ‘Internet’ port of the router
8) Open a web browser and visit http://192.168.3.1
9) When prompted for sign in credentials, please input the following:
Username: admin Password: Bonding123 (we recommend that you change this password)
10) In the menu positioned at the left of the displayed web page, select ‘Status’ followed by ‘Click for WAN
Interface Status’. The status of each Ethernet WAN connection can be confirmed using the following
information:
Link – An interface link showing successfully as ‘Up’ indicates that a physical connection to a
powered-on ISP router/modem exists
Sharedband Connected – A ‘Yes’ status indicates that the interface is communicating
successfully with the Sharedband aggregation service
Troubleshooting ‘WAN Interface Status’
If the WAN-side routers (provided by your ISP) you are connecting to the Sharedband routers don't operate
DHCP, you will need to set a static IP on each Ethernet interface to enable communication. The following
guidance explains how to achieve this:
a) Connect a computer to the blue ‘Internet’ port of the Sharedband router
b) Open a web browser and visit the IP address of the router (default is 192.168.3.1)
c) Sign in to the router when prompted
d) In the menu select ‘Settings’
e) Select the desired ’WAN connection setup (Ethernet)’ interface that you wish to reconfigure
f) In the ’IP Addressing Mode’ drop down, select ‘Static IP’ as per the screenshot below:
To Next Page
Loading...
