TP-Link TL-WR940N - Page 5

5
Internet Parameters Configuration
A Configuration for PPPoE
Note
This page will then display.
This page will then display.
A
fter completing the above configuration, please skip to Wireless Settings
Configuration.
Wait for the Router to detect the
connection type.
If PPPoE is detected, the screen will pop up as shown in A. Please proceed to AǗ
If Static IP is detected, the screen will pop up as shown in B. Please skip to BǗ
If Dynamic IP is detected, the screen will pop up as shown in C. Please skip to C.
1. Make sure the cable is securely plugged into the WAN port before
detection.
2. If the connection type your ISP provided is PPTP, L2TP or BigPond (o
r
Heart Beat Signal), you must go to “Network > WAN” to configure you
r
connection type manually.
Click Next
Select
Click Next
Enter the Username and
Password provided by your ISP
Click Next