40
Operating the Bluetooth source
The MP 2500 R’s integral Bluetooth interface provides a means of transferring
music wirelessly from devices such as smart-phones, tablet PCs, etc. to the
MP 2500 R.
For a successful audio Bluetooth transfer from a mobile device to the
MP 2500 R the mobile device must support the A2DP Bluetooth audio transfer
protocol.
Selecting the Bluetooth
Audio source
Briefly tap the buttons on the front panel of the MP 2500 R, repeatedly if
necessary, or the button on the FM1000 remote control handset until
the source BLUETOOTH is displayed on the screen.
Setting up audio transfer
Before music from a Bluetooth-capable device can be played through the
MP 2500 R, the external device must first be registered to the MP 2500 R. As
long as the MP 2500 R is switched on and no device is connected, it is always
ready to receive. In this state the screen displays the message 'not connected'.
This is the procedure for establishing a connection:
Start a search for Bluetooth equipment on your mobile device.
When it finds the MP 2500 R, make the connection to your mobile
device.
Once the connection is successfully established, the message on the
MP 2500 R’s screen switches to 'connected to YOUR DEVICE'.
If your device requests a PIN code, this is always '0000'.
The procedure for establishing a connection can only be made if the Bluetooth
source is activated (see chapter “Basic settings of the MP 2500 R”).
Due to the large number of different equipment on the market, we are only able
to provide a general description for setting up the radio connection. For detailed
information please refer to the operating instructions supplied with your device.
Information on the piece of music currently being played is displayed on the
screen of the MP 2500 R if this function is supported by the device connected to
the unit.
The behaviour and method of operating the connected mobile device are
determined by the device itself. In general terms the function of the buttons of
the MP 2500 R or the FM1000 remote control handset are as follows:
The / buttons on the remote control handset or the front panel
are used to start and pause playback (PLAY / PAUSE function).
Pressing the button halts playback.
A brief press on the / buttons during playback causes the
device to jump to the next or previous piece of music within the current playlist.
Please note that many AVRCP-capable mobile devices do not support the
controlling through the MP 2500 R. In case of doubt, please ask the
manufacturer of your mobile device.
To Next Page
Loading...