BLUE M
Blue M - - DC 146 Series Industrial Ovens, Models DC, DCW, DCI, DCC
Page 32
5.11 Application of Power
Before energizing any equipment, make a visual inspection for loose components, electrical connections,
fittings, etc. Shut all operating switches to the “OFF” position before energizing.
Have trained personnel start and check out the equipment before its first cycle.
Motor Rotation Check: Units with three phase motors must be checked to insure proper motor rotation. A
red arrow is located on the motor housing of three phase motors to show proper rotation. If it is opposite,
shut down the oven and disconnect the main power supply source. Perform Lock-Out / Tag-Out
Procedures established by your company. Reverse two of the line feeds to obtain proper operation. Failure
to check motor rotation may result in DAMAGE TO THE EQUIPMENT due to opposite airflow, or no airflow.
To Next Page
Loading...
