TQ TQ4000 - Configure Channel; Set Location; Set Number of Channel; Set Number of Relays

Page 10 of 27 Filename: 7970H8
2. TQ4000 Setup and Configuration
The TQ4000 can be configured via a menu system. The menu system is
manipulated using the MENU, UP, DOWN, and SELECT buttons on the TQ4000
main board. The Menu System is password protected and when the MENU button
is pressed the user is prompted to enter the system password. The default
password is 6197. The user must use the UP and DOWN buttons to select the
required digit and then press the SELECT button to accept that digit. After the four
digits are input the password is checked for validity. If the password is accepted
the LCD will display the menu options which may be navigated by using the UP and
DOWN buttons, which will enable the user to scroll through the menu items. The
menu items will wrap around from the last menu item to the first menu item and
vice-versa. To select the desired menu item, the user must press the SELECT
button.
2.1. Set Number of Channel
The number of channels may be selected by pressing the UP and DOWN
buttons to display the required number of channels. The SELECT button is
pressed to accept the displayed number.
2.2. Set Number of Relays
The number of relays may be selected by pressing the UP and DOWN buttons
to display the required number of relays. The SELECT button is pressed to
accept the displayed number.
2.3. Configure Channel
Channel parameters may be set and edited by entering the Configure
Channel menu option. Once entered, the display will prompt the user to
select a desired channel for editing. The user must press the UP and DOWN
buttons to display the required channel location and then press the SELECT
button to accept that channel location.
2.3.1. Set Location
The channel locations are set by default to “CHANNEL 1”, “CHANNEL
2”, etc. This option will allow the user to change the name of the
channel locations to a more meaningful description up to 20 characters
in length, including the <SPACE> character.
The user must use the UP or DOWN buttons to cycle through the
alphanumeric characters, pressing the UP and DOWN buttons
simultaneously will toggle between uppercase and lowercase
characters. Press the SELECT button, when the display shows the
desired character, to accept that character. To leave spaces, select the