Page 14 of 27 Filename: 7970H8
2.4. Set Relays
This option is applicable to the selected channel only. If, for example, the
Fault Relay number is required to be applicable for all channels then it would
be more convenient to use the Set Common Relays menu option.
2.4.1. Select Relay Number
The user is prompted to select the desired relay number and therefore
must press the UP and DOWN buttons to display the desired relay
number and then press the SELECT button to accept that relay number.
2.4.2. Assign Relay Fault
Pressing the SELECT button will assign the selected relay as the Fault
relay.
2.4.3. Clear Relay Fault
Pressing the SELECT button will clear the selected relay as the Fault
relay.
2.4.4. Set Relay Fault Type
The fault relay type may be toggled between normally on and normally
off. This is done by pressing the UP or DOWN buttons. The SELECT
button will accept the displayed option. NB. The Fault Relay is always
a latched alarm, i.e. it will NOT automatically clear a fault condition,
and it requires the user to press the RESET Button to clear a fault
condition.
2.4.5. Set Alarm 1 Relay
Pressing the SELECT button will assign the selected relay as the Alarm
1 relay.
2.4.6. Clear Alarm 1 Relay
Pressing the SELECT button will clear the selected relay as the Alarm 1
relay.
To Next Page
Loading...
Need help?
General