TQ Environmental LTD
Product Manual TQ 4000
Filename: 7970H8 Page 15 of 27
2.4.7. Set Alarm 2 Relay
Pressing the SELECT button will assign the selected relay as the Alarm
2 relay.
2.4.8. Clear Alarm2 Relay
Pressing the SELECT button will clear the selected relay as the Alarm 2
relay.
2.4.9. Set Alarm3 Relay
Pressing the SELECT button will assign the selected relay as the Alarm
3 relay.
2.4.10. Clear Alarm3 Relay
Pressing the SELECT button will clear the selected relay as the Alarm 3
relay.
2.4.11. Exit Sub Menu
Pressing the SELECT button will exit from the alarms sub menu and
return the user to the main menu.
2.5. Set Common Relays
This option operates the same as the Set Relays option above; however, it is
applicable for all channels.
2.6. Clear Relays
This option will allow the user to clear all the relay assignments for the
selected channel.
2.7. Display Relays
This option will display the current relay assignments for the selected
channel. The channel location, alarm relay, and relay number will be
displayed for one second on the LCD. If more than one relay has been
assigned to the selected channel then the subsequent relays will be displayed
in one second intervals.
2.8. Calibrate Channel
This option will allow the Calibration of a sensor. Once entered, the display
will prompt the user to select a desired channel for calibration. The user must
To Next Page
Loading...
Need help?
General