Tracer SimRacer - Function Descriptions; Key Programming Functionality; Sensitivity Adjustment

To Next Page

To Previous Page

Tracer SimRacer 6in1

Instructions for use

5. Function Description

5.1 Key programming function (with memory)

5.1.1 Programming Introduction

1. Programming source keys are: /1/ /Y, /3/B/A, /4/Y/ , /2/A/B, L1/5/ LB/L, L2/7/LT/

ZL, R1/6/RB/R, R2/8/RT/ZR

2. Programmed keys are: the left (L2/7/LB), right (R2 /8/RB), gas ( /2/Y+) feet, foot brake

( /1/Y-), L3/11/SL, R3/12/SR, shift lever.

5.1.2 Programming Settings

1. Press the PROG key once, and the red LED blinks quickly.

2. Press the Programmed button once, and the red LED slowly ashes.

3. Press the programming source key once, the red LED will be long bright, and the pro-

gramming is completed.

5.1.3 Programming Clear

1. Press the PROG key once, and the red LED blinks quickly.

2. Press the Programmed button once, and the red LED slowly ashes.

3. Press the „Be programmed” button again, the red LED lights up, and the programming

is cleared step by step.

5.1.4 Clearing all Programming

1. Press the „PROG” key once, and the red LED blinks quickly.

2. Hold down the OPTIONS/MENU key for 4 seconds, the red LED will be long bright,

all the programmed functions will be cleared, and the sensitivity will return to the initial

default state (low on PC, medium on other hosts).

Note: Since the programming has memory, all the programming Settings will still be retained

after the steering wheel power failure.

5.1.5 Programming Exit

1. Press the „PROG” key once, and the red LED ashes quickly. If no action is taken, the

program will exit automatically 10 seconds later.

5.2 Sensitivity Setting:

1. Press PROG once. The red LED blinks quickly.

2. Press the left or right button of the cross key once, the sensitivity is set to medium, and

the red LED is long and bright. The setting is successful.

3. Or press the upper key of the cross key once, the sensitivity is set to high, and the red

LED is long and bright, the setting is successful.

4. Or press the down button of the cross key once, the sensitivity is set to low, and the red

LED is long bright, the setting is successful.