17
Tracer SimRacer 6in1
EN
Instructions for use
5.3 Calibration method
1. Set the directional gear switch to 270° gear.
2. Holding Down L1+L2+R1+R2 at the same time causes the LED to blink.
3. Turn the direction left to the maximum, and the LED blinks slowly when it reaches the
maximum; Then turn right to the maximum, to the maximum LED slow. Flash, then
return to the center, LED ash.
4. Then, from right to left, push the foot pedal to the end. When hitting the end, the LED
blinks slowly, and when releasing the hand, it blinks quickly.
5. When the LED blinks slowly at last, press the OPTIONS/MENU key to make the LED
light up and the calibration is completed
5.4 Function description of the three-foot pedal
1. Three-foot pedal with clutch function can only be used with game support. List of com-
patible games on www.tracer.pl
2. The left pedal serves as clutch function, the middle pedal serves as brake function, and
the right pedal serves as refueling function.
3. If the game does not support clutch function, the clutch pedal has no function or may
be a brake function.
4. In games that support clutch function, if clutch is set and stepped on, the vehicle will not
move when refueling or braking.
5.5 External 6+1 Shift Lever Function Description
1. When the 6+1 shift lever is connected, it is the steering wheel protocol mode, and it can
only be functional with game support.
2. The LO-HO button on the right side of the shift lever is used to switch the high and low
gears. If the gears start to be 1, 2, 3, 4, 5, 6 low gears, short press this switch, the gears
will be changed to 7, 8, 9, 10, 11, 12 high gears, and the LED indicating the gears will
be long bright.
3. The high-low gear switching function can only be used if the game supports it. (Cur-
rently only truck games support this feature).
4. „P” button on the left side of the shift lever is the handbrake function. Hold down this
button to start the handbrake state, and release it to release the handbrake state. (re-
quires game support).
6. Function introduction of each platform
Attention! To connect the PS4, Xbox 360, Xbox 360 One, Xbox 360 One X controller to the
steering wheel, use a classic 4-core USB cable (not included), the two-core USB cable for
powering portable devices is not suitable for use with the steering wheel.
The 4-core cable is a classic USB cable that can be purchased at any store (as a separate
product without a companion device).
To Next Page
Loading...