2. GP car or boat connection diagram :
11. Function Interface
11.01 D/R
D/R is used to change the action range of steering servo when turning the
steering wheel. Increasing D/R will make steering wheel action more sensitive.
D/R adjusting value range : 0 – 120%。Adjusted by the panel knob switch.
11.02 EPA
Use this when performing left and right steering angle adjustments, throttle
high side/brake side operation amount adjustment, and channel 3 servo up
side/down side operation amount adjustment during linkage.
EPA adjusting value range: 0 – 120 %, default is 100%
1. Press “ENT” to see FUNCTION menu.
2. Use the +/- Keys to select the EPA
function and press “ENT”.
3. Use the +/- Key to change the value
when black box flashing
4. Press EXIT to save the setting and
return to FUNCTION menu.
TERMS: F-FORWARD, B-BACK,
ST—STEERING, TH—THROTTLE,
AUX—3CH
11.03 TEMPERATURE
1- Press the "ENT" key to enter the FUNCTION menu
2- Use the + / - keys to select the TEM function, press “ENT” key to enter
3- Press ENT to select the setting
4- Use the + / - keys to set the value
5- Press EXIT to save and return to FUNCTION screen,
Abbreviation: REAL TEMP - Actual temperature,
WARN TEMP - Temperature alarm
MAX TEMP - Maximum temperature
Note:
98
This feature can know the motor or
engine cooling fin real time temperature
through the sensitive temperature
sensor. You can set the max alarm
temperature up to 150°C,minimum is 0°C
. At the same time it can remember the
maximum temperature at the whole
processing. Tx from turn on to switch off
is a process. Swift off Tx the Max Tem-
perature will clear to zero.
When the temperature reaches the set value of real-time, high-temperature
alarm will start and last for 10 seconds. The maximum temperature of
temperature sensor cable is 200°C, can not be used above .
To Next Page
Loading...
Need help?
General