Trackunit DualID II - Approvals and Certificates; FCC and IC Compliance Statements; RF Exposure and Environmental Standards

Trackunit 501 DualID
_User guide v.1.0
©Trackunit 2017
Approvals and certificates
The DualID II
product is certified according to the following recommendations
FCC and IC Statements
The DualID II product
contains radio transmitters that comply with
with RSS-GEN, RSS-210
of Industry Canada requirements
Notice statements according to CFR 47 Part
The DualID II
product complies with Part 15 of the FCC rules
standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This devi
ce must accept any interference received, including
undesired operation.
Le présent DualID II
appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
NOTICE
statements according to CFR 47 Part 15.21:
Changes or modifications made to this equipment not expressly approved by Trackunit may void the FCC
authorization to operate this equipment.
Statements according to CFR 47 Part 2.1091 / 2.1093 and OET bulletin 6
The DualID II is declared
RF Exposure Compliance for Exemption from Routine
This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
ATTESTATION: It is attested
that the radio
the routine evaluation limits in
RSS102
prepared and the information contained therei
evaluation
methodologies have been followed; and that the device meets the SAR and/or RF field
strength limits of RSS‐102.
EC/ International
• The DualID II product
compl
directive with respect to the EMC requirements, safety and radio spectrum matters.
• The DualID II
complies with the essential requirements of the 2011/65/EC directive on the restrictio
of the use of certain hazardous substances in electrical and electronic equipment.
Including:
(EN/IEC 60950-1
:2006
And environmental testing covering
vehicles/machinery:
_User guide v.1.0
Approvals and certificates
product is certified according to the following recommendations
:
contains radio transmitters that comply with
CFR 47
Part 15.225
of Industry Canada requirements
for RFID reader equipment
Notice statements according to CFR 47 Part
15.19 / RSS-GEN:
product complies with Part 15 of the FCC rules
and with Industry Canada license exempt
subject to the following two conditions:
(1) This device may not cause harmful interference, and
ce must accept any interference received, including
interference that may cause
undesired operation.
appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
statements according to CFR 47 Part 15.21:
Changes or modifications made to this equipment not expressly approved by Trackunit may void the FCC
authorization to operate this equipment.
Statements according to CFR 47 Part 2.1091 / 2.1093 and OET bulletin 6
5 / RSS
RF Exposure Compliance for Exemption from Routine
Evaluation Limits
located or operating in conjunction with any other antenna or transmitter.
that the radio
communication apparatus meets the exemption from
RSS102
Section 2.5 of this standard; that the Technical Brief was
prepared and the information contained therei
n is correct; that applicable measurement methods and
methodologies have been followed; and that the device meets the SAR and/or RF field
compl
ies with the essential requirements of the
RED directive 2014/53/
directive with respect to the EMC requirements, safety and radio spectrum matters.
complies with the essential requirements of the 2011/65/EC directive on the restrictio
of the use of certain hazardous substances in electrical and electronic equipment.
:2006
+ A11, A1, A12, A2):2013 ITE Safety
And environmental testing covering
SAE J1455 heavy trucks for mounted outside
the cabin of the
FCC-ID: ZMF-DUALID-
II
IC-ID: 9746A-DUALID
II
7001.0084 v1.2 23032017
Part 15.225
of the FCC rules and
for RFID reader equipment
.
and with Industry Canada license exempt
interference that may cause
appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
Changes or modifications made to this equipment not expressly approved by Trackunit may void the FCC
5 / RSS
-102:
Evaluation Limits
.
located or operating in conjunction with any other antenna or transmitter.
communication apparatus meets the exemption from
Section 2.5 of this standard; that the Technical Brief was
n is correct; that applicable measurement methods and
methodologies have been followed; and that the device meets the SAR and/or RF field
RED directive 2014/53/
EC
directive with respect to the EMC requirements, safety and radio spectrum matters.
complies with the essential requirements of the 2011/65/EC directive on the restrictio
n
of the use of certain hazardous substances in electrical and electronic equipment.
the cabin of the
II
II