ME500-X
Trackunit ME500-X, Technical Manual v.1.1, January
2016 Page 8
The ME500-X unit cannot be turned off after installation, so any vehicle, moving
machinery, construction machinery installed with ME500-X etc. must not enter any area
with a potentially explosive atmosphere and obey all signs and instructions. Sparks in such
areas could cause an explosion or fire resulting in bodily injury or even death.
Areas with a potentially explosive atmosphere are often, but not always marked clearly.
Potential areas may include: fueling areas (such as gasoline stations); below deck on
boats; fuel or chemical transfer or storage facilities; vehicles using liquefied petroleum gas
(such as propane or butane); areas where the air contains chemicals or particles (such as
grain, dust, or metal powders); and any other area where it would normally be advisable to
turn off motor vehicle engines it is not allowed to enter with a vehicle, moving machinery,
construction machinery installed with the ME500-X.
For Vehicles Equipped with an Airbag
An airbag inflates with great force. DO NOT place objects, including the ME500-X unit, in
the area over the airbag or in the airbag deployment area. If in vehicle wireless equipment
is improperly installed and the air bag inflates, serious injury could result.
Specific Human Absorption Rates (SAR)
THE ME500-X UNIT IS NOT DESIGNED TO BE WORN ON A PERSON’S BODY.
AS SUCH, BODY WORN TEST POSITIONS FOR THE ME500-X UNIT
ARE NOT REQUIRED BY EITHER THE IEC 62311 FOR GSM 900/1800 BANDS OR
FCC/IEEE/ICNIRP REQUIREMENTS FOR GSM 850/1900 BANDS.
The ME500-X unit is not intended for handheld use or to be worn on the body. A minimum
separation of ten (8”) inches (20 cm) is to be maintained between the ME500-X and any
persons’ body. Additional information on Specific Absorption Rates (SAR) can be found on
the Cellular Telecommunications & Internet Association (CTIA) Web site at www.ctia.org.
Battery Safety Information
Adhere to the following guidelines to avoid the risk of fire or explosion:
1. Dispose of the used battery according to the instructions provided with the battery.
2. Do not drop, puncture, disassemble, mutilate, or incinerate the battery.
3. Touching both terminals of a battery with a metal object will short circuit the battery. Do
not carry batteries loosely if the contacts may touch coins, keys, and other metal
objects (such as in pockets or bags).
4. Do not stack batteries taken out of the carry case.
5. Do not heat the batteries to try to rejuvenate their charge.
6. Do not exceed the temperature ranges or other environmental conditions specified by
the battery manufacturer.
7. Never use the ME500-X without the battery cover installed.
To Next Page
Loading...
