Why is my Trackunit GPS counting operating hours when the machine is off?
This may be happening because the main breaker is on the negative wire (ground wire from the machine battery). When off, the inputs may register a voltage level and start counting operating hours. To avoid this situation, connect the digital input 4 (pink wire) to the chassis/ground on the machine.
What to do if there is a constant red light in the Trackunit GPS LED?
Verify the location of the unit. Also, move the machine or vehicle for a better GSM signal.
What to do if the Trackunit GPS doesn't reply to SMS command?
Verify the correct GSM number. Check the LED status (see page 6).
What to do if there is no green light in the Trackunit GPS LED?
Verify the location of the unit. Move the machine or vehicle for better GPS reception.
What to do if there is no light in the Trackunit GPS LED?
Check if the red and blue wires are installed correctly or if the fuse is blown.
Guidance on performing installation outdoors for optimal signal reception.
Steps for logging into the Verify my Trackunit service.
Procedure to locate the device using its serial number.
How to check device status, signals, and voltage.
Options for configuring device name, engine hours, and category.
Operating temperature limits for the unit during active use.
To Next Page
General
