TU600B
Trackunit TU600B, Technical Manual v1.0, March 2022 Page 10
Interference
Like all wireless devices, the TU600B may encounter electrical interference that may affect its
performance.
Avoid Body Contact with Device during Operation
Do not operate the TU600B in direct contact with your body. Maintain at least 8 inches (20 cm)
separation between the device and any parts of your body.
Qualified Service
Except for batteries and Subscriber Identification Module (SIM) card, the TU600B contains no user
serviceable or replaceable parts. Non-functioning units must be returned to an authorized service
center for repair or replacement.
Accessories and Batteries
Use only Trackunit approved accessories or batteries. Do not connect incompatible products.
The battery package is a Trackunit design, no other battery designs are compatible with the battery
holder of the TU600B. There is risk of explosion or fire if an incorrect type replacement battery is
forced into the battery holder as contact may generate a short circuit. Additionally, the battery
holder will be destroyed.
Do not exceed the temperature ranges or other environmental conditions specified by the battery
manufacturer, see battery safety chapter below. Dispose of used batteries according to the
instructions provided with the batteries.
Water-Resistance
The TU600B series is water-resistant according to the IP-67 standard. It is however recommended
that it is be used where it is relatively dry and not subjected to either water streams or submersion.
Mounted inside the HW shield a higher water-resistance level to IP-66k and IP 69k can be
achieved.
Detailed Safety Information
Exposure to Radio Frequency Signals
The TU600B unit is a low power radio transmitter and receiver. Periodically the TU600B wakes up
either due to activity or by a timer. When it is ON, it receives and sends out radio frequency (RF)
signals for a short period of time when awake.
To Next Page
Loading...
