Need help?Do you have a question about the TracRac TracONE and is the answer not in the manual?
Assemble the upright component, connecting it to the modular saddle and base.
Prepare the double T-Slot crossbar, including inserting square nuts and tie-downs.
Install the assembled crossbars onto the uprights, ensuring correct orientation and alignment.
Assemble the modular clamp, attaching the hex head cap screw and clamp foot.
Secure the front uprights to the truck using pre-assembled clamps and shims.
Secure the rear uprights to the truck, ensuring proper clamp spacing for load capacity.
General| Type | Truck Bed Rack |
|---|---|
| Material | Aluminum |
| Adjustable | Yes |
| Adjustable Width | Yes |
| Compatibility | Full-size trucks |
| Finish | Powder-coated |
To Next Page
