www.tractorsupply.com For customer support call 1-888-376-9601
2
2
OPERATION
Pull and turn the clutch knob, so the drum can turn freely by hand.
Use hand saver bar to hitch the hook of the cable assembly and pull cable to the
load. Attach the cable hook to the load.
WARNING: Check that there are at least five turns of cable remaining on the drum
before operation. Ensure the clutch knob is in the engaged position.
CAUTION: Clutch must be fully engaged before winching.
Never operate the clutch while drum is turning. Do not readjust clutch knob as it has
been adjusted and permanently locked in place with a thread-locking compound in the
factory.
Press the “IN” button on the switch to re-spool the cable. Press the “OUT” button
to reverse directions. Wait until the motor stops before reversing directions.
Re-spool the cable after completing the operation.
REPLACING THE CABLE
Engage the clutch by turning the clutch knob to the “IN” position.
When inserting the cable into the drum, insert it into the correct end of the hole
provided. Tighten the screws.
Operate the winch an re-spool the cable around the drum tightly.
CAUTION: To keep the stated tension, be sure the cable is wrapped on the drum
tightly.
WARNING: Always replace damaged cable with manufacturer’s identical
replacement part.
MAINTENANCE
Periodically check tightness of mounting bolts and electrical connections. Remove
all the dirt or corrosion and always keep clean.
Do not attempt to disassemble the gearbox. Repairs should be done by the
manufacturer or authorized repair center.
The gearbox has been lubricated using high temperature lithium grease in the
factory. No internal lubrication is required except when being repaired.
When the transmitter is replaced, the same type of transmitter is required for
pairing. The pairing method is as follows
：
Press the power button
→
Press IN and OUT button at the same time (the red light
was flashing) →Turn on receiver for 1-2s (the relay makes a sound of absorption)
To Next Page
Loading...