13
3. Blade tension loose 3. Adjust blade tension.
Blade is twisting
1. Cut is binding blade.
2. Too much blade tension
1. Decrease reed pressure.
2. Decrease blade tension.
Saw arm can not
be raised up after
pushing the raising
button
1.Improper setting of depth gauge 1. Press the emergency stop
Button and RESET.
2. Check the upper limit switch and
stop round
Position. Make sure the limit swit
is always underneath the stop roun
bar.
3. Check the oil gauge ; make
sure the oil is in proper range.
4. Check the motor revolution
direction; make sure the motor
revolution is in
clock-wise direction.
To Next Page
