traegergrills.com
|
23
Question Answer
Why does my grill
re go out on
SMOKE setting?
There may be excess ash in the repot which needs to be cleaned.
WARNING! If the re in the repot
goes out while smoking and there
are sufcient pellets in the pellet
hopper, it is important to complete
the following instructions. Failure to
do so may cause a hazardous “over-
ring” of your grill due to an excess
of unburned pellets in the repot.
DANGER! Turn the switch OFF (O) and
disconnect the power cord. Allow the grill to cool
thoroughly. Open the door and remove all food,
the porcelain-coated grill grate, the grease drain
pan, and the upper and lower heat shields.
WARNING! Remove all unburned pellets
and ash from inside and around the repot.
(See instructions for proper handling and
disposal of ash in on page 21.)
Before replacing the upper and lower heat
shields, grease drain pan, and porcelain-
coated grill grate, plug the power cord into the
appropriate grounded electrical outlet and turn
the switch ON (I). Pellets should fall into the
repot and the hot rod should begin to heat (it
will start to turn red). CAUTION! Do not touch
the hot rod.
When ames start to come out of the repot,
turn the switch OFF (O). Let the grill cool down.
Now you’re ready to place the upper and lower
heat shields, grease drain pan, and porcelain-
coated grill grate back into the grill. With the
door closed, turn the switch ON (I) and turn the
temperature dial to SMOKE. In about 2 minutes,
the pellets will ignite and whitish-gray smoke
will come out of the grill. After the pellets have
ignited, turn the temperature dial to any cooking
setting desired.
If this does not x the problem, contact
Traeger's VIP-365 Customer Service
(see page 26) for assistance.
With the Traeger
Digital Pro
Controller, what
dial setting is
recommended for
starting the grill?
The auto-start procedure is the same for all grill controls. With the door closed, turn
the switch ON (I) and turn the temperature dial to SMOKE. In about 2 minutes, the
pellets will ignite and whitish-gray smoke will come out of the grill. After the pellets
have ignited, turn the temperature dial to any cooking setting desired.
How do I protect
my paint nish?
Use the protective cover on the grill and touch-up paint to repair any scratches.
Touch-up paint is available from your Traeger dealer, or log onto our website,
traegergrills.com.
Every 90 days, use a high-quality car wax on the outside surfaces of the grill.
ONLY APPLY WAX TO A COLD GRILL.
Where can I get a
new part for my
grill?
Check with your Traeger dealer. They
may have the part in stock or can
order the part for you.
In either case, please provide your name, phone
number, address, model, and serial number of
the grill (located on the label inside the hopper
lid), along with the part identication number
from the component diagram or parts list.
Contact Traeger's VIP-365 Customer
Service (see page 26) to place an
order.
To Next Page
Loading...
