Trail Tech ENDURANCE II

To Next Page

3. VEHICLE SENSORS:

Refer to the sensor installation sections. You should install

both the wheel sensor and vehicle power connection.

Installing the power wire enables a continuous and brighter backlight.

Installing the wheel sensor enables speed and distance readouts.

010-ELV-197

Tech Support: (844) 378-8143

technicalservice@apexproductgroup.com

QUICK-START

1. POWER OVERVIEW

2. MOUNT ENDURANCE II:

5. SLEEP MODE:

4. MAINTENANCE REMINDER:

Endurance II can run on the internal 3.0V watch type

battery (#CR2032).

Install the power wire to enable the continuous backlight.

Endurance II is polarity independent and has safeguards

to avoid draining the vehicle battery. See the POWER

CONNECTION section for more info.

Endurance II is made to be bolted to the vehicle. Use

the included handlebar mounts, or refer to the manual

or www.trailtech.net for other options like the CNC

aluminum protector.

Endurance II goes to sleep if no vehicle activity is detected.

During sleep mode Endurance II uses the internal battery and will not draw down vehicle power.

a. Wakes on external power

b. Wakes on wheel movement

c. Wakes on button press

d. Backlight shuts off after 90 seconds of inactivity

e. LCD shuts off and clock is displayed after 180 seconds of inactivity.

Endurance II’s maintenance icon appears after the countdown gets to 0. Increase the countdown in DATA SETTING MODE.

The countdown can be based on either DISTANCE or TIME, select your preference in DATA SETTING MODE.

Aluminum

Protector Mount

(optional)

Power Wire Wheel Speed

Sensor (varies)

Included

Handlebar

Mount

Other manuals for Trail Tech ENDURANCE II

Manual2 pages

Quick Start Guide2 pages

Need help?

Do you have a question about the Trail Tech ENDURANCE II and is the answer not in the manual?

Summary

POWER OVERVIEW

MOUNT ENDURANCE II

VEHICLE SENSORS

MAINTENANCE REMINDER

SLEEP MODE

BUTTONS

SCREENS

DATA SETTING MODE

WHEEL SENSORS INSTALLS

KTM WHEEL SENSOR

Details installation for KTM/Husqvarna specific wheel sensors.

CONVENTIONAL FORK SENSOR

Describes mounting a VHB fork sensor to the fork.

INVERTED FORK WHEEL SENSOR

Explains installing a fork guard wheel sensor.

ROTOR SHIELD WHEEL SENSOR

Covers sensor installation on UTV/quad rotor shields.

BRAKE CALIPER WHEEL SENSOR

Details mounting a sensor directly to an ATV brake caliper.

C-BRACKET WHEEL SENSOR

Explains using a C-bracket for sensor mounting.

MAGNET INSTALLATION

Guides on installing magnets on brake rotors.

WHEEL SENSORS SETUP

WHEEL SENSOR TEST

Procedure to test sensor and magnet placement before mounting.

MEASURE WHEEL SIZE

Methods for accurately measuring wheel size for calibration.