Assembly Instructions
Important: Once assembled, please ensure before use that
all screws have been installed correctly and tightened for
safety and stability
.
Step 4
Position the pedal plate into the frame and add the screws
according to your preferred position. Note. To adjust the
pedal angle simply loosen the screws by around 2mm, re-
position then tighten.
Step 1
Please use the inner hexagon spanner to remove the 4
screws from the FS3 base.
Step 2
Adjust the lower upright arms to your preferred angle
then re-insert the screws and tighten. This can be
adjusted later for added comfort.
Step 3
Use the inner spanner to remove the 4 screws from the
pedal plate.
Step 5
Attach the Trak Racer branded center inserts of the
frame to the lower upright arms at the front with the holes
facing inwards as below.