OPERATION
SCALE USE
CALIBRATION & WARRANTY
•
•
•
•
•
•
•
Press the ON/OFF button.
•
•
•
•
•
•
Obtain Warranty online:
tramexmeters.com/register
Press Scale button to select the required
mode.
Press MEP fully against the surface of the
material.
Readings are instant and displayed on the
analog screen.
Last scale used is memorized when power is
shut down and automatically selected next
time unit is powered up.
Turn Audio signal on or off by pressing
HOLD/AUDIO twice in quick succession.
To freeze the readings press the HOLD/AUDIO
button once, LED for selected scale will flash
slowly.
If MEP is shut down in HOLD mode, it will retain
the stored reading when powered up next and
remain in HOLD mode with the LED for the
selected scale flashing.
Automatic power timeout (10 mins) conserves
battery life.
Upper scale (5-30) indicates moisture
content (MC%) of wood when used on wood
products.
Lower Scale (0-100) is a comparative scale and
may be used for recording and comparing
moisture condition in materials other than
wood.
Annual calibrations are recommended as
best practice. Calibration Check Boxes can
be purchased for regular checks:
Product code: CALBOXMEP
To Previous Page
Loading...
Need help?
General
