OPERATION
•
•
•
•
•
•
•
•
•
Press fully against the surface of the material
When using with the app, place and press the
meter on the surface, record the reading, lift
and repeat.
Press to switch ON/OFF.
Press to select the required mode/scale.
Last scale used is memorized when power is
shut down and automatically selected next
time unit is powered up.
Hold/freeze: Press once. In HOLD mode
the Hold LED will flash continuously. Press
again to release hold. (If powered down while
on Hold, the Skipper 5 will retain information
until powered up and hold is pressed again to
release)
Turn Audio signal on or off by pressing
HOLD/AUDIO twice in quick succession.
Automatic power timeout (5 mins) conserves
battery life.
Readings are instant and displayed on analog
dial.
To Next Page
Loading...
Need help?
General
