17
SKIPPER 5 MOISTURE METER USER GUIDE
9. The instrument will automatically power-off
after five minutes if no button is pressed or if no
change in meter reading is detected. If a button
is pressed or the meter reading changes, the
power-off will be extended for a further five
minutes.
10. To freeze readings press the HOLD/AUDIO
button once. While on Hold, the LED for the
selected scale will flash slowly. This facility is
extremely useful if readings are being taken in
areas where it is difficult to see the instrument
dial. To remove freeze, press the HOLD/AUDIO
button again..
Best Practice
It is advised when using the Skipper 5 with the App
to avoid sliding or dragging the meter across the
surface under test. Place and press the meter on
the surface, record the reading, lift and repeat.