Page 5
INSTALLER'S GUIDE
STEP 4 - Remove the three screws holding the Heater
Blank Off Plate and remove the plate. The screws
must be retained for later use. The Blank Off Plate
may be discarded.
STEP 5 - Insert heater assembly into heater compart-
ment.
1. Move factory wiring out of the way.
2. Slide heater into heater compartment of air handler.
STEP 6 - Attach heater to coil assembly.
1. Use three screws removed in Step 4 to attach the heater
to the coil flanges in the locations shown on the heater
at the right.
Attach points
To Next Page
Loading...
