Page 6
INSTALLER'S GUIDE
STEP 1 - Route High Voltage wiring to unit.
STEP 2 - The conduit entry point is located on the
top of the unit when in the Upflow configuration.
1. Remove plug from the entry point, if present.
STEP 3 - Route conduit (if used) to the entry point
and connect.
1. Use one hand to secure the conduit nut from inside of
the heater compartment.
2. Connect field supplied 3/4" conduit to conduit nut.
STEP 4 - Connect the mating high voltage
harnesses on the heater and the air handler
cabinet.
Conduit Entry Point
Section 5. Electrical Connections
High voltage
harness plug
High voltage
harness plug
To Next Page
Loading...
