Supplementary
Electric Heaters
for Air Handler Installations
INSTALLER'S
GUIDE
IMPORTANT — This Document is customer property and is to remain with this unit. Please return to service information
pack upon completion of work.
© 2012 Trane
ALL phases of this installation must comply with
NATIONAL, STATE AND LOCAL CODES
18-GJ09D1-5
10/12
Models:
BAYEVAC05BK1A
BAYEVAC05LG1A
BAYEVAC08BK1A
BAYEVAC08LG1A
BAYEVAC10BK1A
BAYEVAC10LG1A
BAYEVBC15BK1A
BAYEVBC20BK1A
BAYEVAC10LG3A
BAYEVBC15LG3A
Table of Contents
Section 1. Safety Information .......................................................................................................1
Section 2. General Information .....................................................................................................2
Section 3. Heater Assembly Labeled ...........................................................................................2
Section 4. Heater Selection...........................................................................................................3
Section 5. Adjust Heater ...............................................................................................................5
Section 6. Install Heater ................................................................................................................7
Section 7. Tables ..........................................................................................................................12
Section 8. Sequence of Operation .............................................................................................14
Section 1. Safety Information
SAFETY HAZARD! This information is intended for use
by individuals possessing adequate backgrounds of electrical
and mechanical experience. Any attempt to repair a central air
conditioning product may result in personal injury and/or property
damage. The manufacturer or seller cannot be responsible for the
interpretation of this information, nor can it assume any liability in
connection with its use.
LIVE ELECTRICAL COMPONENTS! During in-
stallation, testing, servicing, and troubleshooting of this product,
it may be necessary to work with live electrical components.
Failure to follow all electrical safety precautions when exposed to
live electrical components could result in death or serious injury.
SAFETY HAZARD! Sharp Edge Hazard. Be careful of
sharp edges on equipment or any cuts made on sheet metal while
installing or servicing. Personal injury may result.
HAZARDOUS VOLTAGE! Disconnect all electric
power, including remote disconnects before servicing. Follow
proper lockout/tagout procedures to ensure the power can not
be inadvertently energized. Failure to disconnect power before
servicing could result in death or serious injury.
To Next Page
Need help?
General
