Page 7
INSTALLER'S GUIDE
STEP 2 - Disconnect & Dispose of Pigtail Harness.
1. Cut the wire tie that is holding the pigtail harness.
2. Unplug and dispose of pigtail harness.
Important: If using a BAYSUPFLGA, B, or C Supply
Duct Flange Kit, install the kit before inserting the
heater.
STEP 3 - Insert heater assembly into heater compart-
ment.
1. Move factory wiring out of the way and into the grooves
provided in cabinet.
2. Slide heater into heater compartment of air handler.
Section 6. Install Heater
STEP 1 - Remove Heater Compartment Panel.
Heater
Compartment
Panel
Breaker
Cover
Pigtail
Harness
Wire Tie
To Next Page
Loading...
