6 Numbers in [brackets] are for 50 Hz international systems. 32-5038-06
User’s Information
4. Ensure the power cord is plugged into the air cleaner.
5. Press the POWER button to turn on the air
cleaner.
Carefully review BOTH of the COLLECTION CELLS for
the “200/200-1” mark. If the “200/200-1” mark is visible
on BOTH COLLECTION CELLS, they may be washed.
If the “200/200-1” mark is NOT visible, the COLLECTION
CELLS cannot be washed.
CAUTION
!
Washing COLLECTION CELLS that do NOT have the
“200/200-1” mark on them can result in degradation
of the air cleaner system. Failure to follow
instructions could result in property damages.
1. If the COLLECTION CELLS do have the “200/200-1”
mark on them, they may be washed using a low
pressure water spray, such as a sink sprayer or
garden hose. Residue like tobacco smoke may
require warm water to be removed.
• Do NOT use soap or detergent in cleaning the COL-
LECTION CELLS.
• Do NOT immerse the COLLECTION CELLS com-
pletely in water.
• Do NOT place the COLLECTION CELLS into a dish-
washer to clean.
• ALLOW THE COLLECTION CELLS TO DRY THOR-
OUGHLY BEFORE INSTALLING.
Fig. 16
Rotate latches to secure door.
Fig. 15
Fig. 13
Rotate door to closed position. Ensure ends of door
overlap cabinet. (See detail)
Cabinet Edge
Plug Power Cord
in here
Power Button
Fig. 14
NOTE: Once you press the POWER button, the first
LED will be on and it will start flashing after the
first 10 [12] minutes of indoor fan operation. This
is normal operation.
Alternate Cleaning option for homeowners with 200
or 200-1 COLLECTION CELLS ONLY
Vacuuming the PRE-FILTER and COLLECTION CELLS
restores them to a high efficiency. However, some
environmental conditions, like tobacco smoke, cause
the COLLECTION CELLS to need to be washed with
water. Washing the COLLECTION CELLS is
acceptable ONLY if the COLLECTION CELL has a “200/
200-1” embossed or written on the frame in the vicinity
of the manufacturing part number:
To Next Page
Loading...
Need help?
General
