11
Preparation Before Operation
■■
■■
■ Setting the air purifying filters
Indoor unit
● Holding down ( ) or ( ) button
rapidly increases or decreases the time display.
■■
■■
■ Setting the clock
Press .
Press
TIMER
to set the clock to the present
time.
■■
■■
■ Turn the breaker ON
● On normal power-up operation, the louver
will open completely and the close. (This is a
normal procedure.)
Pull out the air filters.
● Push upwards the
tab at the center of
each air filter, then
pull it down.
2
Open the front grille.
● Hold the grille by the tabs on the two sides
and lift it until it stops with a click.
(about 60°)
1
Set the air purifying filters.
● Attach an air purifying filter to each air filter.
(See page 15 “Care and cleaning”)
Set the air filters in their original
positions and close the front grille.
● Operation without air filters may result in
troubles as dust will accumulate inside the
indoor unit.
3
4
1
is displayed.
2
AM
Display
blinks.
3
Press .
blinks.
(Now the clock is set.)
PM
Display
PM
Display
NOTE
Please note
● When the main power switch is turned on, some
watts of electrictly is being used even if the
system is not operating.
Turn off the main power supply switch for saving
energy.
● If you are not going to use the air conditioner for
a long period, for example in spring or autumn,
turn the breaker OFF.
●
Use the air conditioner in the following conditions.
Mode
COOL
DRY
Operating conditions
Outdoor temperature : 60 to 115 °F
Indoor temperature : 64 to 90 °F
Indoor humidity : 80% max.
Outdoor temperature : 60 to 115 °F
Indoor temperature : 64 to 90 °F
Indoor humidity : 80% max.
If operation is continued out of this range
• A safety device may work to stop the operation.
(In multi system, it may work to stop
the operation of the outdoor unit only.)
• Condensation may occur on the indoor unit and drip.
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and drip.
Tips for saving energy
● Be careful not to cool the room too much.
Keeping the temperature setting at a
moderate level helps save energy.
Recommended temperature setting
For cooling: 79°F – 82°F
● Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors
increases the cooling effect.
● Clogged air filters cause inefficient
operation and waste energy. Clean them
once in about every two weeks.
Don’t touch the metal parts of the indoor
unit. If you touch those parts, this may
cause an injury.
01EN3P102561-6F.p65 03/06/04, 9:23Page 11 AdobePageMaker6.5J/Win
To Next Page
Loading...
