6. Precautions
Do not use or store the DrivePro Body 20 in the following places to prevent malfunction or
deformation:
In extremely hot, cold or humid places such as in a car parked in the sun
Under direct sunlight or near a heater
Near strong magnetic fields
In sandy or dusty places
Care and storage of the DrivePro Body 20 lens
Wipe the surface of the lens clean with a soft cloth in the following cases:
When there are fingerprints on the lens surface
When the lens is exposed to salty air such as at the seaside
Store in a well-ventilated location subject to little dirt or dust
To prevent mold, periodically clean the lens as described above
Cleaning
Clean the DrivePro Body 20 surface with a soft cloth slightly moistened with water, then wipe the
surface with a dry cloth. Do not use any of the following as they may damage the finish or the casing:
Chemical products such as thinner, benzine, alcohol, disposable cloths, insect repellent,
sunscreen orinsecticide, etc.
Do not touch the camera with any of the above on your hand.
Do not leave the camera in contact with rubber or vinyl for a long time.
Moisture condensation
If the DrivePro Body 20 is brought directly from a cold to a warm place (or vice versa), moisture
may condense inside or outside the camera. This moisture condensation may cause
malfunction of the DrivePro Body 20.
If moisture condensation occurs, turn off the DrivePro Body 20 and wait about 1 hour for the
To Next Page
Loading...
Need help?
General
