TRAPP TR 200 - User Manual

Questions and Answers

M
mendozasabrinaJul 27, 2025
Why is it difficult to start my TRAPP TR 200 Paper Shredder motor?
- M
  Mark AndersonJul 27, 2025
  If you're having trouble starting the TRAPP Paper Shredder motor, there could be a few reasons. First, check for voltage drops in your electrical network; an electrician can help with this. If it's a gasoline engine, ensure it has gasoline of good quality and refill if necessary. Also, for gasoline engines, try operating the manual choke before starting.
C
Christopher GeorgeAug 2, 2025
What to do if my TRAPP TR 200 is bushing?
- T
  tjenkinsAug 3, 2025
  If your TRAPP Paper Shredder is bushing, it's likely due to excess feeding. To resolve this, disconnect the equipment and wait for the motor to completely stop. Then, open the feeding funnel and remove any excess material inside the machine. Close the funnel, reactivate the motor, and wait for it to reach maximum rotation before restarting your work. Be sure to control the power supply to avoid overloading the motor.
M
margaretclarkAug 9, 2025
Why is my TRAPP TR 200 Paper Shredder's production so low?
- E
  Elijah JonesAug 9, 2025
  Low production in your TRAPP Paper Shredder may be due to insufficient feeding of the machine. Ensure the feeding is continuous but not excessive to prevent bushing.
A
Amanda HuffmanAug 14, 2025
Why is my TRAPP TR 200 Paper Shredder production so low?
- D
  dmorrisonAug 14, 2025
  Low production in your TRAPP Paper Shredder is likely due to insufficient feeding of the machine. To resolve this, ensure you control the feeding to maintain a continuous flow of material, but avoid overfeeding to prevent bushing.
J
Julie GloverAug 20, 2025
What to do if my TRAPP TR 200 bushing?
- M
  Matthew HarrisonAug 20, 2025
  If your TRAPP Paper Shredder is bushing, it's likely due to excess feeding. Here's what to do: 1. Disconnect the equipment and wait for the motor to completely stop. 2. Open the feeding funnel and carefully remove any excess material inside the machine. 3. Close the feeding funnel. 4. Activate the motor and allow it to reach maximum rotation. 5. Restart your work, carefully controlling the material feed to avoid exceeding the motor's capacity.