TRAPP TR 200 - Page 27

ENGLISH
27
www.trapp.com.br
Tightening
 Due to the constant vibration of the equipment, the
natural tendency with time is for screws to loosen.
Therefore, a periodical check is recommended, and
if necessary tighten the screws. Tighten with caution
so as not the strip screw thread.
Attention!
Turn off shredder and remove electrical
plug from outlet before cleaning or
servicing.
Access to the Blades - TR 200 and TR 200G
1
3
2
4
Image merely illustrative
To have access to the blades, proceed as described
below:
 Loosen the knob (1), spring washer (2) and flat
washer (3).
 Now join the feeding funnel (4) to access the blades.