SETTING UP YOUR FX100
POWER ON/OFF
To turn on your FX100, long press and release the
power button. The LED bulb will light up and an audio
cue will indicate the system is on. To turn the FX100 off,
long press and release the power button. Audio cue
will indicate the system is off.
BLUETOOTH
®
1. Pairing: For Bluetooth
®
pairing, press and hold the
power button for 6 secs. The Bluetooth
®
LED will
blink RED/BLUE rapidly indicating device is in
pairing mode.
2. Using your Bluetooth
®
enabled device scan/search
for available Bluetooth
®
devices
3. Select TREBLAB FX100 from the device list.
4. Once FX100 is successfully paired and connected,
the LED will blink BLUE every 3 secs.
5. Disconnect by holding the power button for 6 secs.
RECONNECTING
After the connection is lost, the FX100 will try to
reconnect automatically to any previously paired devices.
If reconnection does not happen automatically, please go
through the “pairing” instructions above.
AUX INPUT
To play audio using the supplied audio cable, plug the
cable from the audio device to the “LINE IN” jack on the
side of the FX100.
To Next Page
Loading...
