TREBLAB HD-Force - Page 9

6. Once HD-Force is successfully paired and connected, the BLUE state
indicator will stop flashing and stay BLUE.
RE-CONNECTING
After the initial pairing, the speaker will automatically connect to the previously
paired device when turned ON again. If reconnection does not happen
automatically, the speaker will start looking for any other previously paired device
within the effective distance range. TREBLAB HD-Force can remember up to 6
recently paired devices.
NOTE: The speaker remembers the last mode it was in before it has been turned
OFF. So, if the speaker is turned OFF in the SD card mode (considering that the
MicroSD card is still in the speaker), after being turned back ON, it wil
automatically go back to the SD card mode.