TREBLAB HD55 - Setting Up Your TREBLAB HD55; Power On and Off; Bluetooth Pairing and Reconnection; Auxiliary Input Connection

Setting Up Your HD55
To turn on your HD55, long press and release the power button.
The LED bulb will light up and an audio cue will indicate the
system is on. To turn the HD55 off, long press and release the
power button. Audio cue will indicate the system is off.
BLUETOOTH ®
POWER
ON/OFF
RECONNECTING
After the connection is lost, the
HD55 will try to reconnect
automatically to any previously
paired devices. If reconnection
does not happen automatically,
please go through the “pairing”
instructions above. TREBLAB
HD55 only can remember the
last 8 paired devices.
1. Pairing: For Bluetooth® pairing, press and
hold the power button for 6 secs. The
Bluetooth® LED will blink RED/BLUE
rapidly indicating device is in pairing mode.
Using your Bluetooth® enabled device,
scan/search for available Bluetooth®
devices
2.
Select TREBLAB HD55 from the device list.
3.
Once HD55 is successfully paired and
connected, the LED will blink BLUE
every 3 secs.
4.
Disconnect by holding the power button
for 6 secs.
5.
AUX INPUT
To play audio using the
supplied audio cable, plug the
cable from the audio device to
the “LINE IN” jack on the side of
the HD55.