Never disassemble or modify your
speaker for any reason. Doing so may
cause the speaker to malfunction or
become combustible. Damaging the
speaker will void your manufacturer’s
warranty. Do not use excessive force
when operating the speaker. Do not
let the speaker drop onto a hard
surface.
Avoid exposing the speaker to
extreme temperatures (below
32F/2Co or above 104F/40Co).
Extreme temperatures may cause the
deformation of the protective cover
and reduce lifespan of the HD55.
Avoid putting LED lights close to the
eyes of humans and animals.
Do not use the speaker outdoors
during a thunderstorm. Thunder-
storms may cause malfunction and
increase the risk of electric shock.
The LED does not come on when turning
the speaker on
This can happen when the battery has lost
charge. Charge the HD55 for at least 30
minutes and the problem should be solved.
Can't connect the speaker to your device
1. TURN OFF THE HD55.
2. Go to the Bluetooth menu on your source
device and delete all saved devices from the
list by clicking on “Forget this device”.
3. Turn the Bluetooth on your source device
OFF then back ON; TREBLAB HD55 will be
deleted.
4. Power OFF your source device then and
then turn it back ON.
5. Power ON the HD55.
6. Enter the device into the pairing mode and
follow the instruction for connecting.
My device is asking for a password
If prompted for a password, enter
0000 on your device.
Frequent disconnection and noise
1. Ensure the HD55 is fully charged.
2. Ensure that the distance between
your device and the speaker is less
than 30 feet / 10 meters.
3. Ensure that nothing is blocking
the signal between your device and
the HD55.
4. Check if the music is paused.
5. Check if the volume level is set
both on the source device and on
the speaker.
6. Check if the speaker is running
out of power.
TROUBLESHOOTING INSTRUCTIONS
To Next Page
Loading...
