SETTING UP YOUR HD77
Turn ON
Press and hold the POWER button for 3 seconds. You will hear the sound cue,
and the BLUE LED light will start flashing.
Turn OFF
Press and hold the POWER button for 5 seconds. You will hear the sound cue,
and the RED LED will light up and go OFF.
WIRELESS PAIRING
Make sure TREBLAB HD77 is fully charged and that the AUX cable is not
plugged in.
1. Turn ON your speaker by pressing and holding the POWER button for 3
seconds. You will hear the sound cue and the LED will start flashing BLUE,
indicating that the speaker is in pairing mode.
2. Activate the Bluetooth mode on your device (smartphone, tablet, laptop).
3. Select TREBLAB HD77 from the Bluetooth devices list. Keep it within 3 feet 1
meter of the speaker while pairing.
4. If necessary, enter passcode 0000.
5. Once HD77 is successfully paired and connected, the LED will stop flashing and
stay BLUE.
To Next Page
Loading...
