TREBLAB X1 - Pairing a Single Earbud

When you tum the earbuds on, they wil try to reconnect with the recenty
connected device. If the reconnection does not happen automatically,
the earbuds will try to find the next device in the pairing list. You can
only connect and piay audio from one device at a time. But you can save
Up 106 connected devices I the paing st
NOTE:
The earbud, which LED is flashing green and red during the painting,
is the main one. For better performance, keep your smart device
closer to the main earbud.
To pair one earbud only
1. Take one earbud out from the charging case. The earbud should start
flashing green and red indicating that It s In the pairing mode.
2. Activate Bluetooth on the Gevice, scanisearch for TREBLAB X1,
and click CONNECT,
3.1f prompted by your device to connect, select Yes.