TREBLAB X1 - Pairing and Connection Problems

Device doesn't find
TREBLAB X1
Frequent disconnection
and noise
Make sure the X1 buds are not paired with
any other device, a5 they can pair only with
one device at a time.
If X1 are in pairing mode and one of the
earbuds flashes green and red, but stil s
ot found by your device, please restart your
device and the headset.
Reset your earbuds to the factory settings
by following the steps from the previous
section. Try to pair again.
Make sure that the distance between your
device and the earbuds is less than 33 feet/
10 meters.
Make sure that nothing is blocking the signal
between your device and your X1 earbuds.
Ifthe earbuds are on, but disconnected from
the device for longer than 10 minutes, they
will automatically tum off to save power.