TREBLAB X1 - Charging the Case

1.To charge the case
To check the case battery level, press the MFB on the rear side of the
case orjust open the case lid. There are 3 LEDS indicating the respective
battery leve:
RED - 0-30% of the battery
BLUE - 30-80% of the battery
GREEN - 80-100% of the battery.
When the case s fully discharged, there will be no LED indication on
the case when you press the MF8 or open the case lid.
We recommend charging the case when the battery level reaches 0-30%
(red LED). To do 5o, plug it to a power source using the supplied Type-C
cable. You willse the red LED on the front side of the case. It takes up.
t0.2 hours to fully charge the case. When the case is charged, you will
see the greed LED on the front side of the case.