TREBLAB XR700 - Initial Setup and Pairing; Powering On and Off; Device Pairing Guide

SETTING UP YOUR TREBLAB XR700
TumON
Press and hold the POWER button for 3 seconds.
Youwill heara ‘Power ON" voice prompt, and the blue & red
LED light will start flashing
Turn OFF
Press and hold the POWER button for 3 seconds.
You wil hear a ‘Power OFF" voice prompt. and the flashing
blue LED light will go off.
Pairing
Make sure TREBLAB XR700 s fully charged and turned OFF.
Press and hold the POWER button on the right earbud
You will_hear the "Power ON" voice prompt. and
*PAIRING' a few seconds later (LED will flash red and
blue rapidly). Release your finger.
2. Activate the wireless connection option on your smart
device and keep it within 3 feet / 1 meter while pairing.
Using your smart device, scan/search for available
devices.
4. Select TREBLAB XR700 from the device list.
5. If prompted for the password, enter 000",
6. 0nce XR700 is successfully paired and connected. you
will hear a *CONNECTED" voice prompt. and the LED
will start lashing blue every 6 seconds
TREBLAB XR700 can be paired to only 1 device at a time.
The system will prevent pairing with any other devices. To
‘connect XR700 to another device: