TREBLAB XR700 - Maintenance and Charging Procedures; Restoring Factory Settings; Earbud Charging Guide

© Frequent Ensure that the distance between
disconnection your device and the headset is less
and noise than 30 feet / 10 meters.
Ensure that nothing is blocking the
signal between your device and the
XR700.
Check fthe music is paused.
Check ifthe volume level s set both
on the source device and on the
speaker.
Check if the headset is running out
of poweer.
RESTORE FACTORY SETTINGS
To restore the earphones back to factory settings:
1 Putthe headset to charging.
2 Press and hold the POWER button for 3 seconds while
charging, unti the LED flashes blue 3 times.
3 Now the earphones are restored back to factory
settings and ready to be paired again.
CHARGING
One full battery charge provides up to 4 hours of playing
time at maximum volume, and up to 8 hours at medium
volume. When the battery is running low. you will hear a
“BATTERY LOW" voice prompt.
To charge the earbuds, plug one end of the supplied cable
into the Micro-USB charging port under the ruibber cover of
the right earbud. Plug the other end of the charging cable
intoa standard USB port It takes up to 3 hours tofully charge.