treesse
treesse
Pg. 13
? DESCRIPTION OF PARTS
/
Temperature
By pressing one of the two scroll keys, it is possible to vary the setting
of temperature of + /- 0.5 °C.
During the adjustment of the temperature, the LED is active.
After 3 seconds of inactivity, the display will return to standby and the
relative LED will turn off.
The temperature can be set from 10 °C to 40 °C.
Upon switch-on, the system will load to the last value set.
The standard value upon first start-up is 35 °C.
Light/Colour Therapy
By pressing the LIGHT/COLOUR THERAPY, you will activate the
colour therapy colour sequence.
The function can always be activated, even with no water level in the
spa.
The sequence of colors varies automatically among 16 shades every
15 seconds.
By pressing the LIGHT/COLOUR THERAPY key again, the colour
enabled at that time is disabled. By pressing it repeatedly, you can
manually scroll through the colors.
By pressing the LIGHT/COLOUR THERAPY key for 2 seconds,the
function will be disabled.
If not turned off manually, the function will stop automatically after 3
hours.
Cleaning the sand filter
The water is filtered through a sand filter coupled to the recirculation
pump.
Filter cleaning serves to maintain effective its filtering function.
The function can be activated manually, automatically, and following
a no-flow alarm.
Cleaning is independent of the filling, emptying, hydromassage
functions or of the presence of alarms; during cleaning the
recirculation pump, the heater and the ozonator are disabled.
During the cycle, the HYDROMSSAGE LED flashes.
It is recommended that you change the sand every 5 years, contacting
to company's support centre.
IMPORTANT
CONTROL PANEL
To Next Page
Loading...
