2023 Domane SL/SLR
1
Safety
WARNING
Tighten hardware properly
Always tighten hardware to the specied torque.
Over-tightening hardware could deform or break the
hardware or components. Under-tightening hardware
could cause hardware or components to become loose.
Either situation could damage the bicycle and result in
injury to the rider.
WARNING
Re-apply threadlocker
All reused-fasteners with a pre-applied threadlocker
must be cleaned with isopropyl alcohol and have new
threadlocker applied before re-assembly. If a threadlock-
er is not applied, the fasteners may loosen, which could
damage the bicycle and result in injury to the rider.
Legend
Apply appropriate grease
Apply threadlocker
Nm
Torque
Cable (zip) tie
Contents
Routing – mechanical
(SL only)
Routing – mechanical
(SL only): instructions
Routing – Di2 Routing – Di2:
instructions
Routing – eTap
Routing – eTap:
instructions
Fork and headset Install the headset Fork and headset –
standard stem
Seatpost
IsoSpeed IsoSpeed: remove and
install
Chainkeeper Storage door Specications
Copyright 2022 Trek Bicycle Corporation All Rights Reserved