10
8. In the Edit Wireless Group window, enter the wireless network name/SSID for the wireless
network. (e.g. TRENDnet-WiFi)
Note: The SSID is the wireless network name used to broadcast and be discovered by your
wireless client devices to connect to your wireless network.
9. For Roaming options, select 802.11k and OKC wireless roaming protocols to ensure
fast transition wireless connectivity for client devices when roaming between multiple access
points.
10. For Authentication method, select WPA/WPA2-PSK. For the WPA Cipher, select AES and
enter the Pre-Shared Key required to connect to your wireless network. Click OK.
Note: The pre-shared key is the key/password (8-63 alphanumeric characters) client devices
will be required to enter in order to connect to your wireless network.
11. The initial wireless settings are complete. You can use the included hardware to mount the
access points to the desired locations.
Note: The access points must be connected to the same IP subnet as your wireless controller.
(e.g. 192.168.10.x / 255.255.255.0)
7. In the list below, click Create to create a new wireless profile.
To Next Page
Loading...
Need help?
General
