11. The initial wireless settings are complete. You can use the included hardware to
mount the access points in the desired locations.
Note: The access points must be connected to the same IP subnet as your wireless
controller. (e.g. 192.168.10.x / 255.255.255.0)
12. To mount the access points, install the mounting plates first to the desired wall or
ceiling using the included drywall anchors and screws. Install the mounting plates with
the clips facing away from the wall. If wall mounting, install the mounting plates with
the correct orientation. After the mounting plates are properly installed, align the access
point mounting holes with the mounting plate clips and slide in access point to lock into
place.
To Next Page
Loading...
Need help?
General
