Gigabit PoE Injector (TPE-113GI)
Standards
IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
IEEE 802.3ab Gigabit Ethernet
IEEE 802.3af Power over Ethernet
Network Media
10 Mbps: UTP/STP Cat. 5 and 5e up to 100 Meters
100 Mbps: UTP/STP Cat. 5, and 5e up to 100 Meters
Gigabit: UTP/STP Cat 5e and 6 up to 100 meters
Ports
1 x 10/100/1000 Mbps DATA-IN (Data only)
1 x 10/100/1000 Mbps PWR+DATA OUT (Data + Power)
Data Lines
Pair 1: Pin 1, 2
Pair 2: Pin 3, 6
Power
Input: 100~240V, 50~60Hz, 0.4A max.
Output: 48V DC, 0.5A 18W max.
Power Consumption
15.4 Watts (max.)
Dimensions (W x D x H)
70 x 45 x 25mm (2.75 x 1.8 x 1 in.)
Weight
45 g (1.6 oz.)
Temperature
Operation: 0°C~50°C (32°F~ 122°F)
Storage: -20°C~60°C (-4°F~140 °F)
Humidity
Max. 90% (non-condensing)
Certifications
CE
FCC
Disclaimers
*For wireless controller compatibility, access points must have the corresponding
firmware versions listed below.
TEW-755AP (Firmware Version: 1.03 or above)
TEW-821DAP (Firmware Version: 1.05 or above)
TEW-825DAP (Firmware Version: 1.01 or above)
**Maximum wireless signal rates are referenced from IEEE 802.11 theoretical
specifications. Actual data throughput and coverage will vary depending on
interference, network traffic, building materials and other conditions.
***Due to regulatory requirements, the wireless channels specified cannot be statically
assigned, but will be available within the available wireless channels when set to auto.