4
5. The WPS button will stop blinking when the WPS process has finished. Confirm that the Wireless
LED is on.
Note: If the Wireless LED lights in blue, the wireless connection to the router is good. If the
Wireless LED lights in red, the wireless connection is weak. Consider to change the extender's
location to have better wireless connection to the router.
Wireless
6. If the TEW-822DRE fails to connect, repeat steps 3 – 5 or proceed to Section 3 Manual Setup.
7. Install the TEW-822DRE in the final location. For maximum performance, install the
TEW-822DRE in a location where there is at least 2 bars of connection from your WiFi router to a
mobile device.
Existing Router
TEW-822DRE
To Next Page
Loading...
Need help?
General
