To Next PageTo Next Page
Need help?Do you have a question about the Trevi 106-206-118-218 and is the answer not in the manual?
General| Brand | Trevi |
|---|---|
| Model | 106-206-118-218 |
| Category | Swimming Pool |
| Language | English |
Consider bylaws, mark area, remove grass, and order materials for site prep.
Level ground, optionally excavate, clear debris, pack soil, and add sand/stone dust layers.
Dig drain hole/trench, connect components, secure hose, position assembly, and apply cement base.
Insert and space wall tracks on joiner plates to form a complete circle.
Prepare wall, align holes, insert into tracks, reinforce, adjust fit, join ends, and secure.
Improper wall joint installation voids warranty and risks serious injury or death.
Spread and level approximately 10 cm of compacting sand, removing debris.
Set up vacuum, secure hose/skimmer, place liner centrally, unfold, align seam, secure fringe.
Adjust liner tension, fill pool partially, and install pump return/bottom drain fittings.
Attach uprights to bottom plate/track, then secure top plate to upright with screws.
Ensure upright is plumb, place top seat, center it, and secure with screws.
Attach top seat cap to seat edge, secure bottom part, and fasten two-part cap with screw.
Install safety labels externally at pool access points and internally for visibility.
Assemble skimmer, inlet, drain, filter, pumps, and hoses per manufacturer's instructions.
Maintain pool, check codes, ensure drainage slope, and prevent unauthorized access.
Keep lifesaving equipment such as a shepherd's crook or throwing rope readily available.
Follow ladder rules: one person, face ladder, no jumping, check fasteners, inform others.
Ensure supervision, have emergency gear, follow pool rules, avoid diving/influence.
Avoid entrapments, manage electrical safety, secure ladders, and install barriers.
